Dragon industrial forklift battery is made of high quality plate grid alloy， unique production process， strengthen board gate corrosion ability， extend the service life of the product. Effectively prevent short circuits and active material loss， heat sealing type design， effectively prevent leakage and enhance reliability High antimony type gate design， high corrosion resistance， the greatest degree to reduce active material loss， improve the circulation of the battery discharge times， increase the service life of the battery Porous type acid corrosion resistant plate， high electrical conductivity， micro glass fiber mat board design， more effectively prevent the active material fall off Special alloy materials made battery terminals， special plating design to reduce the production of heat， reduce the electric shock impedance design Open type environmental design note with holes is easy to check the liquid level， convenient maintenance Precision multi-channel process and all of the tests， from the electrolyte and a gas leak. Special electrolyte formula， prolong service life， 50% more than ordinary battery cycle life. Any position， can install and use any form， without being limited by the space， convenient and safe. Special grid arrangement design， precision casting technology， strengthening plate corrosion resistance. Dragon industrial battery forklift battery per group working time can reach 8 to 10 hours， charge and discharge to reach more than 1200 times， work greatly satisfy the customer requirement， in use process has the advantages of low water loss， maintenance cycle is short， good control characteristics such as discharge smoothly for a long time And in the process of charging， the capacity to reach saturation state， the comparability， improve past a car battery state， the two groups to reduce the operation cost of enterprises. Because the float charging， battery inside most of the oxygen absorbed by plate back into the electrolyte， so no need to like general battery measure the proportion of the electrolyte and hydrating， high rate discharge characteristics， adopt the special plate hole rate is extremely high， and terminal and polarity a molding and internal resistance is small. Especially in the large current characteristics. Welcome calls negotiate more dragon forklift battery matching scheme.
龍工叉車蓄電池采用優質板柵合金、獨特生產工藝，增強板柵抗腐蝕能力，延長產品使用壽命。有效地防止短路和活性物質脫落，熱封型設計，有效避免漏液，增強可靠性；高銻型極柵設計，高耐腐蝕，最大程度降低活性材料脫落，提高電池的循環放電次數，增長的電池使用壽命；多孔式抗酸耐腐蝕隔板，較高的導電性能，微玻璃纖維氈板設計，更加有效防止活性物質脫落；特別的電池端柱由合金材料制造，特殊的電鍍?cè)O(shè)計減少熱量的產生，降低電阻抗震動設計；開口式環保設計注配孔易于檢查液面，方便維護；精密工藝及全線多道的檢測，免除電解液及氣體漏出。特殊電解質配方，延長使用壽命，比一般電池循環壽命提升50%。任意位置，任意形式均可安裝使用，不受空間限制，方便安全。特殊格子體排列設計，精密的鑄造技術，強化極板耐腐蝕性。龍工叉車蓄電池平均每組蓄電池工作時間可達到8-10小時，充放電次數達到1200次以上，大大滿足了客戶工作使用要求，在使用過程中具有失水少，維護周期短，長時間平穩放電等良好的操控特性；還有在充電過程中，容量容易達到飽和狀態，這一可比性，改善以往一車兩組蓄電池囧態，降低了企業的運營成本。由于浮充電時，電池內部產生的氧氣大部分被極板吸收還原成電解液，所以完全不需象一般蓄電池那樣測量電解液的比重和補水，高倍率放電特性優良，采用了孔率極高的特殊極板，并且端子和極性一次成型故而內阻較小。特別是大電流特性優良。歡迎來電洽談更多龍工叉車蓄電池配套方案。